Hold the throttle trigger on the handle, press both levers, and push the starter to the “i”, or start, position. Press down on the starting lockout lever and squeeze the trigger.
Electric models are much easier to start than gas ones, and the procedure can be described in a sentence:
How to start a weed eater stihl. Insert the spark plug and turn it clockwise until tight with an adjustable wrench. Hold in the throttle trigger and pull the starter cord to start the weed eater. Wipe the spark plug dry with a shop towel;
Fill the fuel tank if you have not done so yet. The slicing instrument will rotate. Use the recommended oil ratio to gas ( 50:1) and stihl.
Slide the choke lever to the “run” position. In this video, we demonstrate how to properly and safely start your stihl trimmer. You will learn the basic safety procedures, the primary steps to starting your stihl trimmer and the importance of checking the choke.
If not, then it could result in the weed eater overheating. The cutting tool will rotate. First, you must remove the filler cap and fill the tank with a 50:1 gas to oil ratio fuel.
On a flooded engine, the spark plug is damp on the bottom and smells strongly of gasoline. Tighten the 'l' screw all the way, then turn it one turn counterclockwise to open it. However, when it comes to the electric corded and cordless weed trimmer models, things get a little bit simpler.
Start up the engine and allow it to warm up. Turn the weedeater so the spark plug reservoir is facing either down or away from you. Many new and proud stihl trimmers are faced with the question;
How to regulate the carburetor on a stihl weed eater. How to start an electric weed eater. Click to see full answer.
If playback doesn't begin shortly, try restarting your device. How to adjust the carburetor on a stihl weed eater. Now, lay the weed eater to the ground.
This is an important step on how to start a stihl weed eater. No matter how hard you try, your weed eater won’t start on an empty tank. Starting of a stihl weed eater may vary depending on the model.
Begin the engine and permit it to heat up. Pull the spark plug straight out of the weed eater. Weed trimmers can be a pain to start at times, and when they start to get old, sometimes they need a little help to get some gas into the cylinder head.
The spark plug on a flooded weedeater is very wet with excess gas. Place the weed eater on firm ground and do a general check to make sure the trimmer head is not touching any obstacles. Stihl weed eaters have two models:
Pull the starter cord quickly 10 to 15 times. A weed eater engine is a delicate piece of equipment that requires a good and constant air flow to keep operating. No matter how hard you try, your weed eater won’t start on an empty tank.
Tighten the ‘l’ screw all the best way, then flip it one flip counterclockwise to open it. How do you start a stihl weed eater? Watch now as he pulls apart 2 dead trimmers to make one fully functioning unit.he is working with.
Can steve make a new grass trimmer from parts? So, in our next discussion, we’re going to learn how to start an electric weed eater. Put the trimmer on a flat surface.
Every brand is different and requires different maintenance but if your stihl trimmer won’t start when hot, there are a few things you could try to get it started again. Watch this video series on how to properly start your stihl outdoor power equipment. Videos you watch may be added to the tv's watch history and influence tv.
While starting a stihl trimmer will vary slightly based on your model, most starting procedures are similar. Start up the engine and allow it to warm up. Place an adjustable wrench on the spark plug and turn it counterclockwise to loosen it.
Replace the spark plug wire on the top of the spark plug. Some use starting fluid for this, but a small amount of gas can work as well, as explained in this article. Make sure the trimmer is laying on the ground and the opposite side of the starter grip handle is the one in contact with the surface.
How to adjust the carburetor on a stihl weed eater. The spark plug cap is black rubber and attaches to a black rubber coated wire. Cold start procedure step 1.
In this video, stihl demonstrates how to properly and safely start your stihl trimmer. Tighten the 'l' screw all the way, then turn it one turn counterclockwise to open it. Place the weed eater on firm ground and do a general check to make sure the trimmer head is not touching any obstacles.
Fill the fuel tank if you have not done so yet. The cutting tool will rotate. Whether you’re getting ready to blow away last season’s leaves, cut some firewood or trim the grass, you’ll learn the tips and techniques you need to get your stihl running right.
Use the recommended oil ratio to gas (50:1) and stihl brand oil. If your trimmer has a priming bulb, which is a small, clear plastic button attached to the trimmer housing over the carburetor, you have to press this several times before pulling the starting. The procedure for starting gas models is a bit more complex.
How to start a flooded stihl weedeater?