Remove the drain cap at the bottom of your sand filter to release the pressure in the filter and drain the water. The filtered water is then returned to the pool.
How to drain an above ground pool?
How to drain an above ground pool with a sand filter. Depending on the type of pool filter, the debris can be flushed from the system or rinsed from the filter. With this, you can completely drain out all the excess water in the pool. Move the valve handle at the top of the filter to the “winter” position.
It is very important that you properly store your filter system for the winter to avoid any damage that could be caused by the freezing temperatures. Using a garden hose to siphon the pool water out To drain it manually, lay plastic sheeting underneath the filter drain assembly, remove the assembly and turn on the pump.
How to drain the water from your above ground pool. The goal, then, is to keep your filter pump, your hoses, and your filter media sorted and safe for winter, ready to go for spring. For less mess, try removing the drain plug and allowing the sand to drain for a few days.
This is the fastest, but messiest way to get rid of the sand from your system. Is used to clean filter sand. The pool store should have told you that in order to replace the screen successfully you have to remove the sand.
Draining water using a submersible pump; In order to use a sand filter, you just need to turn off the pump, place the backwash hose to the draining area, place the filter in waste mode, and turn the pump back on. Rotate the multiport valve on the top or side in a clockwise direction to the “waste” position.
You can use the nozzle to monitor the state in which the water is in and when it is clear, turn off the system and switch the valve to rinse position for about 30 seconds to a minute. Turn off your pool pump. To winterize your sand filter, remove the drain cap at the bottom of the filter tank to let the entire filter drain and leave the drain cap off until spring.
How to drain a pool with a sand filter. Winterizing and storing your sand filter. When it comes to winterize a sand filter for an above ground pool, there are manuals and user guides, which contain sand filter manufacturer’s instructions according to your filter’s model.
Turn the pump back on. However, if your guides are missing, take note of the make and model which is recorded on the filter and check the company’s website for its manual. You must operate the filter system at least eight to twelve hours per day in order to remove wastes effectively.
After you get the correct amount of water out of your swimming pool, turn the pump back off. As you found out, you can't get the screen back in with the sand in there. To remove the multiport valve from the top of your pool filter you will have to remove the pump, return and waste pipes.
You can now remove both hoses that connect the filter to the pool. Now with all of these extra ports open you can turn on the blower again which will cause some mist to blow out of the ports on your filter. Another way to do this is to learn how to drain an above ground pool with a sand filter.
Roll backwash hose out into the yard or approved draining area. After draining your pool for the winter: 3) turn off the blower and change the filter head setting to winter.
A pool filter pump draws water from the pool and pushes it through filter media or material to remove debris and other particles. Remove the drain plug from the bottom of the filter tank and allow all water to drain from the system. At this point i recommend removing the sand, then removing the screen and cleaning the threads really well then reassembling it all correctly.
If you have a bleeder valve or air vent valve on your sand filter you should open this as well. The two most commonly used methods for draining an above ground pool are as follows: Winterizing a sand filter will make you very familiar with your top mount valve, which is located at the top of your sand filter pump.
Use for normal filtration or vacuuming the pool.